current

Tenergy Smart Universal Charger for NiMH / NiCd Battery pack 7.2V – 12V with charging current Selection/Temperature Sensor

Tenergy Smart Universal Charger for NiMH / NiCd Battery pack 7.2V – 12V with charging current Selection/Temperature Sensor

  • Best Charger for charging all RC Car, RC air and Airsoft battery packs 7.2V, 8.4V, 9.6V and 12V.
  • Fast charger with current switch to select either, 0.9A and 1.8A. Deliver full charge within 1 – 2 hours.
  • Worldwide usage with 120-240V AC.
  • Use pulse and negative pulse technology to avoid battery overheating during fast charging, optimized for battery pack’s cycle life.
  • Safety protection fuse for over current, short circuit & reverse polarity protection

Accessories Included

* 1 standard Tamiya Female connector and Fuse house with the smart battery charger.
* 1 connector adaptor from standard Male Tamiya to Mini Female.
* 1 set of clip adaptor with Male Tamiya connector on one end.
* 2 additional fuses

Smart Charger Specification

* FOR 6V-12V NI-MH/NI-CD BATTERY PACK 6-10PCS BATTERY
* Input: AC100-240V
* Output: 6-12V 0.9or1.8A

Operation Instruction

* Connect battery pack to output connector and plug AC power source.
* Make sure battery polarity is connected correctly (Red wire is positive)
* Charger will detect battery voltage automatically, Red LED will be on during charging
* When battery is fully charged, current will reduce to trickle charging at 50mA,Green LED will be on
* Battery will be charged at 0.9A or 1.8A constant current,
* Approximate Charging time is about 1.5hrs for 3000mAh battery,1hr for 1800mAh battery.
* The charger is designed for faster charging NiCd and NiMH battery packs from 6 to 12V for RC car/Air and Air soft gun.
* Don’t charge battery packs with voltage less than 6V or voltage greater than 12V and capacity smaller than1100mAh.
* Battery pack must be made by high drain current cell.
* Please contact your seller for instruction. Mfg is not responsible for any damage and consequent damage by Misusage.

Caution

* The charger is designed for indoor use only. Don’t leave the charger unattended during charging.
* The Charger should be positioned horizontally and work in well ventilated condition, avoid water and keep it away from flammable explosive goods.
* Don’t cover the charger when charging, ambient temperature shall not be more than 40oC
* Don’t touch the plug.
* Don’t leave the abtteries and chargers on wood surface or carpet.
* Cut off the power supply before connect or disconnect the charger with batteries.
* Don’t try to disassemble the charger, High voltage inside, danger!



Related Airsoft Charger Products

Airsoft Tags: